I have started to take a renewed interest in electronics again lately and wanted to get a good soldering station to work with. I have a couple fixed wattage irons I use for my RC plane wiring but I wanted something adjustable with a variety of alternative tips available.
I ordered a Weller WLC100 and it is working pretty well for me so far. I also ordered some smaller conical and screwdriver tips that make it easier to solder smaller components and connections. One of the reasons I went with the Weller is because it is a relatively well know brand and I know I will be able to find tips for it.
There are more expensive solder stations that have digital controls and displays but I decided that an analog control was adequate. After using the station for a bit I am pretty happy with the analog control. The amount of heat transferred is so strongly dictated by the conduction of heat between the iron and the component/pad that I don’t know that such temperature precision makes much difference for most hobby uses. If you just tin the tip of your iron with a little bit of solder it will make significantly help with the transfer of heat from your iron to the component/pad you are soldering.
The Weller iron is easy to grip with my fingers and doesn’t get too hot to handle at all. I built a Herbie the Mousebot Kit with it using a .062″ screw driver tip. It was nice to work with and did the job well. I would definitely pick up some smaller tips if you are going to be soldering smaller circuit boards. The screwdriver tip that comes with it is pretty nice but a small tip affords more precision.
I give the Weller WLC100 5 out of 5 stars. It is a good, relatively cheap soldering station with many tips available. Buy one and a couple tips to go with it:
Leave a Reply
You must be logged in to post a comment.